[Grml] Speakup and non-ascii characters

[Michael Whapples]

Your question about where to put the copy command, better be before the 
exit 0 line as the exit command does what it says and will exit the 
script at that point. Sometimes those exit commands are put in start up 
scripts so you can disable them (IE. the exit command will be near the 
beginning so that either you comment it out to enable the script or 
uncomment it to disable the script).

Michael Whapples
On 25/05/09 13:53, Hermann wrote:
> On 25.05.2009 at 14:34:45 Michael Whapples<mwhapples at aim.com>  wrote:
>
>    
>> I tried some stuff on my system. Here is what I found.
>>
>> When I edited the copy of the table I used nano for my editor and it
>> added an extra blank line and so when I tried to copy the table into
>> /sys/module/speakup/parameters/characters it didn't go in because of the
>> extra line. You should have a single new line character following the
>> last entry in the table (nano made it two new lines). However I didn't
>> get any error message with this copying, it just didn't go in. When I
>> corrected the table and then tried to copy it, everything worked fine.
>>
>>      
> OK, that was it. Reediting the file with emacs did the trick.
> Note: You can change the config file of nano, so that this additional
> line isn't put in. I'll do so.
> One question about /etc/rc.local: Where to put the cp command? Before or
> after that "exit 0" line?
> Hermann
>