* T mlist4suntong@yahoo.com [20060815 23:22]:
On Tue, 15 Aug 2006 22:07:53 +0200, Michael Prokop wrote:
Does '/etc/init.d/networking start' right after bootup work for you?
IIRC, no. but I'm really not sure.
Ok.
How does your /etc/network/interfaces look like? Does it contain a "auto $INTERFACE"?
No, it does not contain the "auto $INTERFACE":
$ cat /etc/network/interfaces # /etc/network/interfaces -- configuration file for ifup(8), ifdown(8) # For more sample entries take a look at /etc/network/interfaces.examples
# The loopback interface # automatically added when upgrading auto lo iface lo inet loopback
Ok, there is no configuration for your device. :)
And it is the same as what I get from booting from the Live-CD.
Sure. The loopback interface is initiated "manually" and all network devices are started via "ifconfig $DEVICE up ; pump -i $DEVICE".
And finally what does 'grep ifup /etc/runlevel.conf' return?
$ grep ifup /etc/runlevel.conf 18 - S /etc/init.d/ifupdown-clean 36 - S /etc/init.d/ifupdown 39 - - /etc/init.d/ifupdown-scripts-zg2
Again, same as from the Live-CD, expect the extra ifupdown-scripts-zg2 line.
Ok.
rings any bells?
How do you bring up your network? :) Seems like you are using a DHCP based setup.
If you want to do it automatically start grml-network and configure it according to your needs. Or manually configure /etc/network/interfaces, take a look at /etc/network/interfaces.examples for some configuration examples.
If you want to use dhcp with the same setup as from live-cd mode make sure that CONFIG_DHCP='yes' is set in /etc/grml/autoconfig and the binary "pump" is available.
regards, -mika-